Calificación:
  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Pole display
#1
Good day we have NCR 5972 2x20 Customer Pole display we have been battling to get it to work with SYSME when it power up it goes to sleep mode. I checked the manual and it says we mus send command 1B 05 Set Display State On. how can it be done?
now when we send data it doesn't display as it is on sleep. see manual attached.
Responder


Mensajes en este tema
Pole display - por Desonline - 03-08-2015, 01:42 PM

Salto de foro:


Usuarios navegando en este tema: 1 invitado(s)

Contáctanos | Sysme Software | Volver arriba | | Archivo (Modo simple) | Sindicación RSS